Sako P94 Finnfire 22LR


  • Varmint/Sundberg Taper: .900″diameter at receiver then a straight taper to .730″at 21″ finish length, weight is 2 pounds 14 ounces (Shown in image above.)
SKU: N/A Categories: ,

Product Description


These barrels are a true match-grade barrel, we only have one grade for all of our barrels, our best. All of these barrels are made from 1″ diameter 416 alloy rifle-barrel-quality stainless steel. Every barrel is drilled, reamed and rifled in our shop followed by a stress relieving heat treatment operation. They are then hand- lapped for a superior internal finish and diameter uniformity. With these drop-in barrels we then turn the shank end of the barrel to the proper dimensions and cut a true match chamber.

The barrel is then cut to final length and crowned with an 11 degree target-type crown. Each barrel is then polished to a 600 grit exterior finish and then our name and the cartridge designation is engraved on the barrel. And lastly the finished barrel receives a final inspection and is sealed in a 6 mil poly tube and placed on the shelf.

Accuracy with the Bull barrel and Sundberg taper is excellent. Groups at 50 yards for 5-shots can be expected to be in the .2’s with target ammo.

Drop-in barrels do not require any special gunsmithing. Directions for installing the barrel are furnished with each barrel. These instructions can also be found directly below.

Finnfire (P94) Installation Instructions


To remove original barrel:

  1. Remove barreled action from stock.
  2. Loosen the (2) socket head cap screws that hold the split
    receiver sections together using a 5mm allen wrench.
  3. Pull original barrel out of action.

To install new barrel:

  1. Bolt should be in closed/cocked position. Slide Lilja barrel into action with a Go Gauge in the chamber until the gauge contacts the bolt face.
    Note: Alignment pin in action fits into extractor slot milled into barrel shank.
  2. Tighten (2) socket head cap screws – locking barrel in place,
    using 5mm allen wrench. New screws are included.
    Note: There should be a small gap between the barrel shoulder and receiver face.
  3. Shoot small groups and have fun!

We offer a .043″ Go Gauge made by Pacific Precison.

Additional Information

Weight 4 lbs
Dimensions 24 x 1.5 x 1.5 in

Varmint/Sundberg Taper